Tripp Lite NGI-M08C4-L2, Owner'S Manual

Page: 206 / 313

206
Priority
Configures the priority for the instance.
Priority is used in determining the root switch, root port and
designated port. The switch with the highest priority (lowest numeric
value) becomes the STP root switch. If all switches have the same
priority, the switch with the lowest MAC address will then become
the root switch. Enter a value from 0~61440.
The lower the numeric value you assign, the higher the priority for
this bridge.
Priority determines the root bridge, which in turn determines the Root
Hello Time, Root Maximum Age and Root Forwarding Delay.
VLAN
Select one or more vlans which will join the instance.
Note: the vlan will be removed from instance 0 automatically.
Apply
Click Apply to take effect the settings.
Refresh
Click
Refresh
to begin configuring this screen afresh.
Instance and vlan map table
Instance The instance.
VLAN The vlan in the instance.
Priority The field displays the priority for the instance.
Action Click Delete button to delete this instance.
6.14.4.2 Bridge Parameters
6.14.4.2.1 CLI Configurations
Node Command Description
enable show spanning-tree mst
configuration
This command displays the MSTP configurations.
enable show spanning-tree mst
instance <0-63> interface
IFNAME
This command displays specific instance
configurations on an interface of the MSTP.
enable configure terminal This command changes the node to configure
node.
configure spanning-tree mst forward-
time <4-30>
This command configures the forward time for
the MSTP.
configure no spanning-tree mst
forward-time
This command resets the forward time for the
MSTP.
The default forward delay time is 15 seconds.
configure spanning-tree mst hello-
time <1-10>
This command configures the hello time for the
MSTP.
configure no spanning-tree mst hello-
time
This command resets the hello time for the MSTP.
The default hello time is 2 seconds.
configure spanning-tree mst max-age This command configures the maximum age time