8
Remote Repeater Installation
14
Turn on the power to the DVI source. The Orange RJ45 LED’s on the
B140-002-DD, B140-110, and B140-1A0, and the Orange Activity LED
on the B140-1A0-WP, will illuminate. The video image should now be
displayed on the connected monitors.
15
If necessary, use the Equalization control on the B140-110, B140-1A0,
and/or B140-1A0-WP to adjust the video image.
Note:
An improper Equalization setting can cause the monitor not to display an image at all.
Try each setting until an acceptable image is displayed.
Troubleshooting
If you are unable to get an acceptable image after following the installation
instructions, try the troubleshooting tips below.
1
Is the external power supply that came with the product connected and
plugged into a working power source? For the product to function properly,
it must be connected to and receiving power from the external power
supply.
2
Was the power to the DVI source turned off prior to installation? If not,
restart your computer.
3
Have you adjusted the Equalization setting on the repeater and/or receiver
units? There are built-in Equalization adjustment knobs on every repeater
and active receiver, which can be adjusted to obtain the best picture
quality. Use the mini screwdriver included with the product to adjust this
setting until an acceptable image is displayed.
Note:
An improper Equalization setting can cause the monitor not to display an image at all.
Try each setting until an acceptable image is displayed.
13-01-085-933287_revA.indd 8
1/30/2013 3:44:20 PM
