Monitor Stand Installation
TOOLS
You will need a long, narrow flat-head screwdriver that has a magnetic tip. You will also
need to be in a well-lit area
.
Step 1: Unboxing & Parts**
The stand ships in two separate pieces—the Base and the Tilt Adjuster—and must be
assem-bled before use. Remove both parts from your case. The Base is the piece with a
bottom that is shaped like a boomreang. The Tilt Adjuster is the piece that has the
rectangular piece of metal mounted on a black plastic circle with a piece of rubber in
between.
Step 2: Removing the Screws and Mounting the Tilt Adjuster to the Base
Remove the screws from the Tilt Adjuster using the flat-head screwdriver. Then, flip the
Base over and place the neck of the Base into the Tilt Adjuster. Line up the screw holes,
then use the screws to connect the two pieces.
Step 3: Mounting the Screen Onto the Stand
Place the Base upright on the table with the feet of the stand facing you. Verify there is
no slack between the Base and the Tilt Adjuster (the connection should be tight; the Tilt
Adjuster may move left and right slightly, but should not have any ability to move up or
down.) Take the HDCM Monitor and look at the back of it. Below the label on the back
of the unit, you will see a slot cut out of the metal case. Place the rectangular piece of
metal on the TIlt Adjuster into that slot.
Step 4: Tighten Tilt Adjuster Against the Monitor
Now that the Monitor is mounted onto the Tilt Adjuster, use the wheel on the Tilt
Adjuster to tighten the connection to the Monitor until the connection is tight enough
that the monitor will not fall out if the stand is picked up and flipped upside down (be
sure to be careful when you are testing this in case you haven’t tightened it down
enough).
Step 5: Tilt Adjustments
To complete the adjustments, loosen the Tilt Up/Down bolt, manually move the Monitor
to the desired viewing angle, and then re-tighten the Tilt Up/Down bolt.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
