ASSEMBLY INSTRUCTIONS
© 2016 TRINITY - 800.985.5506
3
STEP 3
D (2)
E (2)
F (16)
Lay WORKBENCH (A) on its backside. Two
people are needed. Do NOT attempt this alone.
Position LOCKING CASTERS (D) on the side of
the WORKBENCH (A) of your choice and align
holes to pre-installed nuts on the underside of
WORKBENCH (A). Use a 14mm socket wrench
to fully tighten CASTER BOLT (F) to
WORKBENCH (A).
Repeat above step to install the NON-LOCKING
CASTERS (E).
Notes:
* Make sure to install both of the LOCKING
CASTERS (D) on the same side.
** For ease of use, place LOCKING CASTERS
(D) on the side you will regularly push or pull.
*** If you plan to push the Tool Chest against a
wall, place LOCKING CASTERS (D) on the front
long side for ease of access.
14mm
A
Carefully lift Workbench upright. Two people
are needed. Do NOT attempt this alone.
SHELF (I) is shipped upside down at the
bottom inside the cabinet. Tilt SHELF (I)
diagonally and remove from the cabinet. Flip
it over so the flat surface faces up and make
sure the tabs are on 2 sides.
Tilt SHELF (I) diagonally to move it to the
desired position. Once at the desired height,
secure SHELF (I) by pushing down on all 4
corners until SHELF (I) engages fully with the
tabs.
I (1)
STEP 4
E
D
F
I
Position Tab