Trinity ECOSTORAGE TBFZ-0909, Owner'S Manual, Page: 3 / 12

ASSEMBLY INSTRUCTIONS
STEP 2: SLIP SLEEVES
STEP 1: Stationary Option
Screw each FEET LEVELER (G) into the bottom of
each BOTTOM POLE (A). Turn clockwise to screw
in place.
STEP 1: Mobile Option
* For safety and stability, the lowest SHELF (D) should be lower than the 3
rd
notch from the bottom.
** Note: There will be a very small gap in-between the SLIP SLEEVES (E) — this is normal.
© 2017 TRINITY - 800.985.5506
2
A (4)
Screw each CASTER (F) into the bottom of each
BOTTOM POLE (A). Turn clockwise to screw in
place. Make sure the Locking Casters are on the
same side.
Use the provided caster wrench to tighten
completely. Failure to do as instructed could
result in the caster stem breaking.
F (5) G (5)
A (5) E (10)
For easiest assembly, do not connect the TOP POLES (C),
MIDDLE POLES (B), and BOTTOM POLES (A) until
instructed. Once connected, these will be the posts for
the Rack.
Note that each POLE (A+B+C) has slight horizontal line
indentations at 1” intervals. Each SLIP SLEEVE (E) has
raised horizontal lines inside designed to lock them in
place on the POLE (A+B+C).
On BOTTOM POLE (A), place 1 pair of SLIP SLEEVES (E) at
the desired level. Please make sure the arrow faces up
and that the word “TOP” is right side up. Do this for
each BOTTOM POLE (A), and make sure that the heights
are identical for each BOTTOM POLE (A).
Slide the pair of SLIP SLEEVES (E) until you hear a click to
confirm the pair is locked onto the BOTTOM POLE (A).
DO NOT place more than one pair on each BOTTOM
POLE (A) at a time.