ASSEMBLY INSTRUCTIONS
© 2022 TRINITY - 800.985.5506
3
STEP 3
D (2)
E (2)
F (16)
Lay WORKBENCH (A) on its backside. Two people
are needed. Do NOT attempt this alone.
Position LOCKING CASTERS (D) on side of
WORKBENCH (A) of your choice and align holes to
pre-installed nuts on the underside of
WORKBENCH (A). Use a 14mm socket wrench to
fully tighten CASTER BOLT (F) to WORKBENCH (A).
Repeat to install NON-LOCKING CASTERS (E).
Notes:
* Make sure to install both of LOCKING CASTERS
(D) on same side.
** For ease of use, place LOCKING CASTERS (D) on
side you will regularly push or pull.
*** If you plan to push workbench against a wall,
place LOCKING CASTERS (D) on front long side for
ease of access.
14mm
A
STEP 4
E
D
F
G (12)
Place LINERS (G) in each pull-out tray and
each drawer.
Pull-out Tray
G