TriMark UM 34, Instructions Manual

Page: 10 / 13

10
CAN Address Conflict 3
EEPROM Read/Write Error 4
Keypad Status LED’s and Backlighting
The Keypad back lighting is typically off. When a button is pressed, the backlight illuminates
momentarily. After button presses stop, the backlight is low for 30 seconds. After 30 seconds
of no keypad activity the keypad back lights turn off again.
There are two LED lights on the keypad, one next to the 1/2 key (LED1), and one next to the
9/0 key (LED2). The following tables summarize what they indicate.
LED1 LED2 Backlight Mode Software State
On Off On Customer Mode RUNNING power state
Off Off Off Customer Mode PENDING SLEEP or SLEEPING power state
Off Alternating
red/yellow
blinking
On Customer Mode Lockout Mode
Slow blink on both LED’s
for X cycles then pause
On Customer Mode Run-time error detected, see table below
Off Off Blinking Keypad Learn
Mode
Waiting for Authority Code
Yellow, blinking Blinking Keypad Learn
Mode
Keypad Learn Mode active, waiting for user
input
Yellow Yellow Blinking Keypad Learn
Mode
Keypad Learn Mode active, Fob Learn Mode
has been activated on the e-
ASK
module
Fault
Run-Time Error
Blinks
CAN Bus Communication Error 1
CAN Voltage Out of Range, High, Above 5V 2
CAN Address Conflict 3
EEPROM Read/Write Error 4
Problem Description Possible Solution
e- FOB Hints
Fob button press does not provide
correct operation
Verify power and ground connections to the e- ASK
module.
Re-teach the FOB transmitter to the receiver.
No operation or intermittent operation
Mount RF receiver away from enclosed metal areas and
fully extend antenna.
Check FOB transmitter battery voltage. Batteries need to
be changed every 1-2 years depending on usage.
Alarm mode starts when powered up Press Unlock button of FOB transmitter