3 PC 1.5 FT LED SPIRAL TREE PATHWAY
ITEM NUMBER:
TY-S1.5(X3)-60LED
A. Star
Qty
：
3pcs
B. The body of the tree
Qty
：
3pcs
C. Plastic cap
Qty
：
3pcs
D. Pole section
Qty
：
6pcs
E. Tree stand
Qty
：
3pcs
ASSEMBLY INSTRUCTIONS
For indoor use:
(1) Put the tree stand on a flat surface.
(
2) The tree stand has a short vertical section projecting upwards from it. Insert one pole section(with big
end down as shown in diagram A) onto this section.
(3) Insert another pole section on top of existing pole in the same manner. Attach plastic cap on the top.
(4) Slide spiral tree over poles, so the pole runs vertically through the center of the spiral tree. Insert star
into the top of plastic cap.
(5) Insert the hooks at the end of two supporting strings into the two metal holes on two ends of the stand.
(6) Repeat step (1) to (5) for the other trees.
For outdoor use:
(1) One of the end of the tree stand is tapered. Drive this sharp end of the tree stand into the ground with
the plastic cap as shown in diagram B.
(2) Insert one pole section(with big end down as shown in diagram B) into the opposite end of the tree
stand.
(3) Insert another pole section on top of existing pole in the same manner. Attach plastic cap on the top.
(4) Slide spiral tree over poles, so the pole runs vertically through the center of the spiral tree. Insert star
into top of plastic cap.
(5) Insert the hooks at the end of two supporting strings into the two metal holes on two ends of the tree
stand.
(6) Repeat step (1) to (5) for the other trees.
(7) Plug in.
diagram A
diagram B
