48 IN ANIMATED STANDING DEER
ITEM NUMBER:
M4(48)-105L-M
A. Antlers
Qty
：
1pair
B. Neck and head &
connecting bar
Qty
：
1pc
C. Body
Qty
：
1pc
D. Motor with crank
Qty
：
1pc
E. Pin
Qty
：
2pcs
F. Ground stakes
Qty
：
4pcs
ASSEMBLY INSTRUCTIONS
STEPS:
(1) Take out all the parts of the product and place them on a flat surface. If there are any
plastic covers to protect the end of metal rod tips, remove the covers before assembly;
(2) Carefully remove the antlers, head, and neck from inside the body.
(3) Unfold the four legs. Insert the four hooks at the bottom of the body into the corresponding
holes on the inner side of each leg .(See diagram 1,2)
(4) Insert the metal hook on one front leg into the metal loop on the other front leg to secure
them in position .(See diagram 1)
(5) There are two hooks at the top and bottom of the rear edge of the neck. Insert these hooks
into the corresponding holes on the edge of the body and insert the cotter pin pre-attached to
secure them; (See diagram 3).
(6) Insert the hooked end of the connecting bar attached to the neck into the hole at the end of
the crank and insert the cotter pin prep-attached to secure them; (See diagram 4).
(7) Insert the two metal rods at the bottom of the antlers into the holes on top of the head;
(See diagram 5)
(8) Secure the figure onto the ground with ground stakes provided;
(9) Plug in.
Diagram 4
Diagram 3
Diagram 5
