Use of these products in combination with non-Honeywell prod-
ucts in a wireless mesh network, or to access, monitor or control
devices in a wireless mesh nework via the internet or another
external wide area network, may require a separate license from
Sipco, LLC. For more information, contact Sipco, LLC or Ipco, LLC
at 8215 Roswell Rd., Building 900, Suite 950, Atlanta, GA 303350,
or at www.sipcollc.com or www.intusiq.com.
LICENSING STATEMENT
The base includes an area for recording the zone, address, and type of detec-
tor being installed. This information is useful for setting the detector head
address and for verification of the detector type required for that location.
TAMPER-RESIST FEATURE
NOTE: Do not use the tamper-resist feature if the removal tool will be used.
The detector base includes a tamper-resist feature that prevents removal of the
detector without using a small screwdriver or similar tool.
To activate this feature, use needle-nose pliers to break the tab on the detector
base as shown in Figure 3A. Then, install the detector.
To remove the detector from the base once the tamper-resist feature has been
activated, remove the decorative ring by rotating it in either direction and
pulling it away from the base. Then, insert a small screwdriver into the notch,
as indicated in Figure 3B, and press the plastic lever toward the mounting
surface before rotating the detector counterclockwise for removal.
The tamper-resist feature can be defeated by breaking and removing the plastic
lever from the base. However, this prevents the feature from being used again.
FIGURE 3A. ENABLING THE TAMPER-RESISTANT CAPABILITY
PLASTIC LEVER
BREAK TAB AT DOTTED LINE BY
TWISTING TOWARD CENTER OF BASE
USE SMALL-BLADED SCREWDRIVER TO PUSH
PLASTIC LEVER IN DIRECTION OF ARROW
C0130-00
FIGURE 3B. REMOVING THE DETECTOR HEAD FROM THE BASE
USE SMALL-BLADED SCREWDRIVER TO PUSH
PLASTIC LEVER IN DIRECTION OF ARROW
C02009-00
Triga™ is a trademark of TRIGA Life Safety Systems, LLC. SWIFT® and System Sensor® are registered trademarks of Honeywell International, Inc.
2
I56-4064TRG-002
©2021. 2/1/2021
