TRIGA TR-LOC2100, Product Installation

Page: 2 / 2

2 PRELIMINARY:
TR-LOC2100 Product Installation Document —
P/N LS10188-003TR-E:A 04/27/21
3. To reinstall the doors, first align the top hinge and then align the
lower hinge. See Figure 3.
Figure 3 Cabinet Door and Dead Front Panel Removal
2.3 Board Layout
Figure 4 illustrates the TR-2100 back view of the board.
Figure 4 TR-LOC2100 Board (Back View)
3 Wiring to an FACP
To properly wire the TR-LOC2100 to the FACP SBUS, refer to the
Figure 5.
Figure 5 Wiring the to the FACP
3.1 Microphone Installation
To install the microphone, do the following.
1.
Clip the microphone into the microphone clip. See Figure 6.
Figure 6 Microphone with the Microphone Clip
2. Insert the microphone cord through hole on the side of the dead
front panel. See Figure 7.
3. Connect the microphone cord.
Figure 7 Microphone Cord Inserted Through the Dead Front
Panel Hole
4. Attach the strain relief clip to the microphone cord. The strain relief
clip should have about 2¾” (6.99 cm) of microphone cord through
it. See Figure 8.
.
Figure 8 Strain Relief Clip Installation
5. Push the strain into the hole in the dead front panel.
6. Restore the AC power and reconnect the backup batteries.
3.2 Optional Accessory
The optional accessory is the THUMBLTCH - Turn latch lock (it is not
intended for UL® installations).
dead
front panel
hinge pin
cabinet door
SBUS
VBUS2
VBUS1
SBUS address
DIPs
Audio
Input
Audio
Trigger
dead front panel
mounting holes
Aux
Aux
supervised
power-limited
FACP
microphone
clip
Connect
microphone
2¾
”
(6.99 cm)