Trieste ED-D6KG, Instruction Manual

Page: 6 / 11

The Dryer should not be pushed so far back that the tube adaptor is pulled
out of position or the tube is squashed or bent.
The tube should be kept clear of the air intake vent and kinks or “U” bends
must be avoided as these will obstruct the tube or trap condensation.
Open window venting
The end of the tube should be directed downwards,
to prevent warm moist air from condensing in the
room or in the dryer.
Ensure that the dryer is adequately ventilated and that the end of the vent
tube is not directed towards the air intake duct.
The vent tube must always be fitted for optimum performance.
Make sure that the vent tube and air intake vents are not obstructed or
blocked.
The dryer must not recycle exhaust air.
Misusing a tumble dryer may create a fire hazard.
Do not discharge exhaust air into a flue which is used for exhaust fumes
from other appliances that burn gas or other fuels.
Electrical connections
Make sure of the following before you insert the plug into the electrical
socket:
The socket must be grounded.
The socket must be able to sustain the machines maximum power,
which is indicated on the rating label (see Dryer Description).
Power voltage must be within the values indicated on the rating label.(
see Dryer Description)
The socket must be compatible with the dryers plug. Should this not be
the case, replace the plug or the socket.
The dryer must not be installed outdoors, even if the space is sheltered.
It can be very dangerous if it is exposed to rain or storms.
Once installed, the dryers electrical wire and plug must be within ease
reach.
Do not use extension cords.
The power cord must not be bent or squashed.
The power supply cord should be checked periodically and replaced by
a cord specially prepared for this dryer and fitted only by authorised
technicians (see Service). New or longer power cords are supplied at an
extra charge by authorised dealers.
The manufacture denies any responsibility should any of these rules not
be followed.
If in doubt about any of the above consult a qualified
electrician
.
Before you start using your dryer
Once you have installed your dryer and before you use it, clean the inside
of the drum to remove any dust that could have accumulated during
transport.