www.tridonic.com
7
Subject to change without notice.
luxCONTROL lighting control system
basicDIM
Data sheet 04/17-CO078-13
Switch
basicDIM ILD has an input terminal for an external switch. Any number of switches can be connected in parallel to the terminal.
Short press (> 50–600 ms):
ON/OFF
Long press (> 600 ms):
Dim up/down
A change in the light value deactivates lighting regulation only temporarily. As soon as the luminaire has been
automatically switched on again (motion detection) or manually switched off and on again, regulation is
activated again.
2 x short press:
The overwritten setpoint light value is stored (luminaire acknowledges by flashing twice)
Function is lockable via the DSI programmer
8 – 9 mm
wire preparation:
0.5 – 1.5 mm²
Wiring diagram basicDIM ILD
DSI/DALI interface
The interface selection DSI or DALI is made by the DSI SMART Programmer.
basicDIM ILD
L
N
T
N
L
PCA
DA
DA
DA
DA
D1
D2
D1
D2
PCA
CH1
CH2
Sensor
2
3
4
6
7
2
3
4
6
7
basicDIM ILD Sensor
Cable types and cable cross-sections
Solid wire with a cable cross-section of 0.5 mm² to 1.5 mm².
basicDIM ILD
L
N
T
N
L
LCA
DA
DA
DA
DA
D1
D2
D1
D2
LCA
CH1
CH2
Sensor
2
3
4
6
7
2
3
4
6
7
basicDIM ILD Sensor
DALI Repeater
DA
DA
DA
DA
OUT
IN
N
L
~
DA DA
Max. 2
Max. 120
PS2
Enhancement of controllable light point
By using a combination of DALI Repeater and DALI Power Supply it is possible
to enhance the sum of controllable light points. The schematic visualizes the
wiring.
Use only in combination with DALI Repeater (86458401) and one of the following DALI Power Supplies:
DALI PS1 (24034323), 200 mA, max. 100 additional devices
DALI PS2 (28000876), 240 mA, max. 120 additional devices
Wire length for 1.5 mm
2
cables:
• from basicDIM to DALI Repeater max. 100 m
• after DALI Repeater max. 300 m
This combination can be used on CH1 and CH2.
