12
Tridak® Model 2200 Cartridge Filling System User Guide
Figure 9. Tank Liner: Method 2
Installing the Nozzle
The proper nozzle should be placed into position by following this procedure.
1. Loosen the Thumbscrew located on the side of the Nozzle Block by rotating it counter-clockwise
2. Insert the Nozzle from the bottom of the Nozzle Block (Figure 11). At the same time, guide the Tube from
the Tank into the opening on the top of the Nozzle. You will feel resistance as the Tube goes by the O-Ring.
This O-Ring should be lubricated occasionally (Figure 12).
3. Push the Nozzle upwards until the Retaining Ring stops against the Nozzle Block. While holding it in
position, tighten the Thumbscrew (Figure 12).
4. Place the Valve into its proper position. The pin in the body must be aligned with the hole in the Pivot
Mount.
5. Swing the Clamp Handle into position and tighten.
Figure 10. Nozzle Block
Figure 11. Nozzle Installation
Seal Adapter
Tube
Tube Adapter
Nozzle
Block
Nozzle
Block
Nozzle
