12
Table 2-1. Mode Indicators
Table 2-2. Power Output Level Indicators
*Applies only to TCR-MBA-50 WB.
Note 1
: The 35 and 50 Watt power levels are only available in military vehicle mode (pin D
grounded on the DC input power connector with a 28 VDC source).
The modes of operation and power levels will cycle in the order indicated in Table 2-1 and Table
2-2 from top to bottom. The settings will cycle through in a loop, to select a different mode or
power level, the mode or power switch must be pressed repeatedly until the next desired mode of
operation or power level is selected. The power levels are selected by momentarily pressing the
PWR button (refer to section 2.3.3). The LEDs for power indication will turn on and remain on
as long as the RF output power is being adjusted and will revert back to their normal function 2
seconds after the desired power level is selected. The power level indication will also
momentarily illuminate when the modes are changed and at initial turn on of the amplifier.
MODE OF OPERATION
LED
LOS MODES
SAT
LNA
WB
LOS
FH
AM
LOS FM
ON
LOS FREQUENCY HOP FM (SINCGARS)
ON
ON
LOS AM
ON
ON
LOS FREQUENCY HOP AM (HAVE QUICK)
ON
ON
ON
*LOS WB ANW2/SRW
ON
*LOS FREQUENCY HOP WB ANW2/SRW
ON
ON
SATCOM MODES
SATCOM LNA ON
ON
ON
SATCOM LNA OFF
ON
MODE OF OPERATION
LED
10 W
15 W
25 W
35W
50W
LOS MODES
RMT
FLT
TX
LVL
LNA
LOS FM/AM SF/FREQUENCY HOP 25 Watts
ON
ON
ON
LOS FM/AM SF/FREQUENCY HOP 50 Watts
(Note 1)
ON
ON
ON
ON
ON
WB MODES
*LOS WB SF/FREQUENCY HOP 25 Watts
ON
ON
ON
SATCOM MODES
SATCOM LNA ON/OFF 10 Watts
ON
SATCOM LNA ON/OFF 15 Watts
ON
ON
SATCOM LNA ON/OFF 25 Watts
ON
ON
ON
SATCOM LNA ON/OFF 35 Watts
(Note 1)
ON
ON
ON
ON
SATCOM LNA ON/OFF 50 Watts
(Note 1)
ON
ON
ON
ON
ON