17
Something not working
IMPORTANT!
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved
with the help of the indications described in the chart, without calling out an engineer.
Switch off the dishwasher, open the door and carry out the following suggested corrective actions.
Fault code / malfunction
Possible cause
Solution
The dishwasher does not fill with
water.
- continuous flashing of the
start / cancel light
- 1 flash of the
"
End
"
light
The dishwasher will not drain.
- continuous flashing of the
start/cancel light
- 2 flashes of the
"
End
"
light
The water tap is blocked or furred
Clean the water tap.
with limescale.
The water tap is turned off.
Turn the water tap on.
The filter (where present) in the .
Clean the filter in the.
threaded hose fitting at the water
threaded hose fitting.
inlet valve is blocked.
The water inlet hose has not been
Check the water inlet hose
correctly laid or it is bent or
connection.
squashed.
The sink spigot is blocked.
Clean out the sink spigot.
The water drain hose has not been
Check the water drain hose
correctly laid or it is bent or
connection.
squashed.
The programme does not start.
The dishwasher door has not been
Close the door
properly closed.
The main plug is not plugged in.
Insert the mains plug
The fuse has blown in the household
Replace the fuse.
fuse box.
Once these checks have been carried out; close the door, switch on the dishwasher and press the
start / cancel
button. The programme will continue from the point at which it was interrupted. If
the malfunction or fault code reappears contact the Service Force Centre.
For other combinations of fault codes not described in the above chart, please contact your
Service Force Centre.
- continuous flashing of the
start / cancel light
- 3 flashes of the
"
End
"
light
Anti-flood device is activated.
Close the water tap and
contact your local Service
Force Centre.
156998 37/0en 7-10-2006 12:20 Pagina 17
