Assembly Instructions
1. Take the antenna bracket - feed arm
assembly, unfold and rotate the feed arm until
it reaches the locking position on the antenna
bracket. (See the illustration below)
2. Fix the locked assembly on to the antenna
using the 4 off M6 12mm painted Pozi-Pan
screws and M6 nuts.
3. Attach elevation bracket to the antenna
bracket using 4 off M6 x 16 cup square
screws and M6 nuts.
4. Check the the LNB skew setting is
appropriate to the location. If adjustment is
required, loosen the clamp screw and reset
to the correct position before tightening.
(See LNB skew setting overleaf) Angle the
front edge of the LNB clamp so it locates
under the return on top of the feed arm.
Whilst supporting the feed arm rotate the
clamp down over the arm ensuring that the
location lugs on the clamp lock securely into
place in the cut outs on the bottom of the
feed arm. Remove the mounting button from
the feed clamp and push through the hole on
the top surface of the clamp through into the
feed arm, ensuring that the button sits firmly
on top of the feed clamp.
1
2
3
4
Rotating Feed Arm Mechanism
