Start-Up
Remote Control
For the remote control you need two batteries of the micro type: AAA/1.5 V.
•
Observing the prescribed polarity, put two batteries into the battery compartment and close
the battery compartment cover again carefully until the cover locks in position.
•
Change batteries that are becoming weak in good time. Always change both batteries at the
same time and use batteries of the same type
•
Leaking batteries can cause damage to the remote control. If the receiver is not used for a long
time, take the batteries out of the remote control.
•
The remote control transmits infrared signals to the receiver. Point the remote control at the
front of the receiver and press the appropriate button once for a short time.
Receiver
Check the proper connection of all devices and the aerial, before you connect the receiver to the
mains power supply.
Switch the TV set on and then switch the AV channel on.
On the back of the receiver, turn on the mains switch. The device will be in normal mode. The
current channel position will be displayed.
The receiver is supplied with pre-programmed television channels and can be used immediately. If
you want to establish whether there are new channels, activate a channel search scan. For this, read
the information on the following pages.
To go into standby mode:
Press the red button on the top right of the remote control. The current time is displayed on
the front of the receiver.
The device only consumes around 2 watts in this mode.
18
Summary of Contents for Digital Satellite Receiver SR 110
