- 23 -
CCS-2 2001
• Press the
button.
—> The "Transmitter identification" – "
COFDM TPS
" menu is activated.
t
r ansmit ter
identifiCation
At terrestrial transmission an identification is referred to each COFDM modu-
lated transmitter. When COFDM modulated signals are fed into cable net-
works this identification is not necessary usually. If receiving problems should
occur you must refer a transmitter identification (CELL ID) to each output chan-
nel and switch "
on
" the transmitter identification.
Bx 4
CELL 0x0000
COFDM TPS
off
• Use the
buttons to position the cursor under the digit of the hexadeci-
mal number to be set.
•
Press
to set the respective digit of the hexadecimal number.
• Repeat the procedure by the quantity of the digits to be set.
• Using the
button place the cursor under "
off
" and switch "
on
" the trans-
mitter identification using the
buttons.
—> By pressing the
button you return to the hexadecimal number
setting.
• Press the
button.
—> You will be returned to the "Output signal" – "
OUTPUT
" main menu
(page 17).
• Press the
button.
—> The "Output channel / Output frequency" – "
OUTPUT
" main menu is
activated.
