![background image](http://html1.mh-extra.com/html/triax/ccs-2-1002/ccs-2-1002_assembly-instructions-manual_1160864032.webp)
- 32 -
CCS-2 1002
• Press the
button.
—> The "Transmitter identification" – "
COFDM TPS
" menu is activated.
t
r ansmit ter
identifiCation
At terrestrial transmission an identification is referred to each COFDM modu-
lated transmitter. When COFDM modulated signals are fed into cable net-
works this identification is not necessary usually. If receiving problems should
occur you can assign a transmitter identification (CELL ID) to each output chan-
nel and switch "
on
" the transmitter identification.
Bx 4A
/B
CELL 0x0000
COFDM TPS
off
• Use the
buttons to position the cursor under the digit of the hexadeci-
mal number to be set.
• Press
to set the respective digit of the hexadecimal number.
• Repeat the procedure by the quantity of the digits to be set.
• Using the button place the cursor under "
off
" and switch "
on
" the trans-
mitter identification using the
buttons.
—> By pressing the
button you return to the hexadecimal number
setting.
• Press the
button.
—> The "Output data rate" – "
STUFFING
" menu is activated.