![background image](http://html1.mh-extra.com/html/triax/ccs-2-1002/ccs-2-1002_assembly-instructions-manual_1160864022.webp)
- 22 -
CCS-2 1002
i
nPut
symbol
r ate
(line a
only
)
The symbol rates of the satellite transponders can be found in the current chan-
nel table of the satellite operator, in various satellite magazines and in the
Internet.
Bx 4A
27500
SYMBOL
DVB-S
• Use
to position the cursor under the digit to be set for the symbol rate
displayed.
• Press
to enter the respective digit of the symbol rate needed.
• Repeat the procedure by the quantity of the digits to be set.
s
et ting
the
dvb
mode
(line a
only
)
The cassette recognizes the transmitted DVB mode and switches over between
the normal QPSK mode (DVB-S) and the DVB-S2 mode. Receiving stations
with DVB-S2 mode, we suggest to preset the DVB mode to shorten the time for
searching stations.
Bx 4A
27500
SYMBOL
DVB-S
• Use the
button to place the cursor under "
DVB-S
" and set the required
DVB-S2-mode with the buttons
.
• Press the
button.
—> The "Input frequency" – "
FREQ
" menu is activated.
i
nPut
frequenCy
(line a
only
)
If three dots "
…
" appear in the second line of the display, the cassette is in
the "
station search
" mode. Please wait until the process has finished.
Once the HF receiver has synchronised to the input signal, any offset to the
target frequency is displayed in MHz, e.g. "
– 1.8
".
If a question mark "
?
" appears in the second line of the display, there is no
input signal present. In this case check the configuration of the antenna system
and head-end station as well as the preceding settings of the cassette.