Triad Bronze Slimsub - Quick Start Guide
2014.5.19
1: Attach cone feet to the standing feet with acorn nuts &
washers (see insert). 2: With cone feet to the back of the enclosure,
securely screw the 2 standing feet into the 4 inserts in the bottom of
the enclosure with 4 button screws and 5/32" Allen key.
Attach grill at one end; snap grill into place
making sure that all 4 magnets are secure and
that grill is snug all around.
A
Securely connect speaker wires (min
14 gauge AWG) through push-in binding
posts. Be sure to preserve correct polarity
with amp (red to red).
Set subwoofer in place. Connect speaker
wires to RackAmp and set up RackAmp with
instructions on Page 1.
C
B
D
InRoom Bronze SlimSub - Upright Installation
OnWall Bronze SlimSub - Installation
Bronze SlimSub
- Installation Instructions -
Page 2
Level & pin template to wall. Sub can be
positioned horizontally (landscape) or vertically
(portrait) with binding posts at either end. Outline
wire hole and all 8 screw holes for 2 mounting
posts. Screw post(s) into a stud if possible.
Cut wire hole; install anchors if there are
no studs. Always screw both mounting posts to
wall with 4 screws per post. Test both posts
for shear strength.
A
Pull speaker wire through wire hole.
Securely connect speaker wires (min 14
gauge AWG) through push-in binding
posts. Be sure to preserve correct polarity
with amp (red to red).
Attach adhesive backed bumper to
each of the 4 back corners. Mount speaker
on posts; loosely tighten knobs through
washers into posts. Level or align +/- 1/4”
(6.35mm), then tighten both knobs.
C
B
D
Assemble
cone feet
1
Attach grill at one end; snap grill
into place making sure that all 4 magnets
are secure. Snug all around. Connect
speaker wires to RackAmp and set up
RackAmp with instructions on Page 1.
E
2
x2
