A
DETAIL A
SCALE 1 : 8
B
C
4b
4c
4a
DETAIL B
SCALE 1 : 10
DETAIL C
SCALE 1 : 8
If you purchased a specialty ladder (ie Deep Top, All Directional, Stock Picking, etc.),
1.
be sure to read ALL instruction packets prior to any assembly.
Place the stringer on a firm working surface, laying on its side. The back and bottom
2.
assemblies ship fastened to the stringer but are folded flat.
Pivot the back and bottom assemblies until their connection holes align. Connect
3.
using 5/16" x 1-1/2" fasteners.
Install support tubes as shown below. Support tubes are connected to the support
4.
tube clamps using hand tightened 5/16" x 1" fasteners. Detailed figures below show
examples of how the support tubes attach to the clamps.
Support tubes 4a connect to the bottom and stringer.
Support tubes 4b (if provided) connect to the back and stringer.
Support tubes 4c (if provided) connect to the back
and bottom. 15 step ladders have their own bolt
location on the back assembly (not shown in picture).
3
2
Attach casters to the bottom assembly
5.
using 5/16" x 1" fasteners.
Attach the guardrail to the top of the
6.
stringer assembly using 5/16" x 1" fasteners.
Attach the handrails on the outside of the
7.
guardrail using 5/16" x 1-1/2" fasteners.
Attach the handrail posts to the stringer using
8.
handrail clamps and 5/16" x 1-3/4" fasteners as
shown at the left.
Prior to standing the ladder upright, be sure to
9.
tighten all fasteners completely, including any that
may have been only hand-tightened earlier.
4
5
6
7
8
