16
-
Extend the accessory adapting it to the dimension of the window.
-
Connect the end fitting to the other side of flexible hose.
-
Insert the end fitting in the oval opening of the window accessory.
The drainage tube can be compressed to minimum 45 cm and extended to maximum
150cm. It is advisable to keep the tube compressed to the minimum.
4. Avoid tight bends and folds in the flexible pipe. The lenght of window accessory is
minimum 93cm, maximum 126cm.
INSERT BATTERIES
The compartment for battery is located under remote control. The remote works with
2 x AAA, 1.5V battery.
-
Open the door by pulling the lock tab. Remove discharged batteries eventually present in compartment.
-
Insert the battery following the signs (+ -) written in the body.
-
Insert batteries, lock them and close the cover.
-
Aim the remote control towards the receiver on the air conditioner.
-
The remote control should be within 6 meters away from the receiver.
-
No obstacles between the remote control and the receiver.
CAUTION
-
Always use batteries AAA, 1.5V type. Be sure to insert the battery according to the correct polarity as
otherwise they may leak and damage the scale. Such damage is not covered by warranty.
-
When you are going not to use unit for a long time, it is advisable to remove battery to prevent run-out.
-
Do not heat, disassemble or throw in fire. Batteries are collected separately. Dispose of exhausted
batteries correctly, as required by national regulation.
OPERATING
This appliance can be used for cooling, dehumidification
and ventilation. When switching between modes, the fan
continues to turn but the compressor stops: the compressor
will re-start after 3 minutes. This delay protects the
compressor from potential damage.
THE DISCHARGE TUBE MUST BE CONNECTED to
the appliance AT ALL TIMES: the only exception is
when the appliance is used in dehumidification mode only, in which case the appliance should be left to
discharge directly into the room for maximum efficiency (see “Dehumidification Mode” paragraph).
Clean the air filters under the removable rear grille regularly to keep the air conditioner working efficiently.
Select the working modes by pressing the
MODE button (3 on remote F on control panel).
1. COOLING MODE (COOL)
The “Cool” LED on the control panel will turn on. The temperature can be adjusted to between 16 °C and 31
°C. In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the
temperature setting and retains this setting when it is switched on again.
In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.
For more silent operation, run the fan at low speed.
2. DEHUMIDIFICATION MODE (DRY)
The temperature cannot be adjusted. The fan speed is set to low and cannot be adjusted.
The air conditioner does not cool the room when operating as a dehumidifier.
When the appliance is used as a dehumidifier, the flexible pipe must not be connected.
For maximum
dehumidification efficiency, leave the rear discharge attachment free to discharge directly into the
environment.
The dehumidification mode is recommended during autumn and winter.
If used during
summer, it is best to leave the flexible pipe attached so that the hot air is discharged outside rather than
in the room.
Note: Only when temperature reaches 17°C can we turn on the dehumidification mode, besides,
the drain pipe must be installed.
