Trevi GO 2500 4K, Manual

Page: 22 / 70

8
User’s manual
Trevi
EN
GO 2500
4K
Instructions for use
1.
Insert microSD card into the port
Make sure to insert the card with the top side facing the screen. The bottom
of the card with the connectors should be directed towards the front of the
camera.
2.
Installation and replacement of batteries
• Slide the battery lock and at the same time open the battery cover.
• Insert the battery in the correct position, so that the battery termi -
nals +/- fit the connectors on the camera. After inserting the
battery, close the battery cover.
• The battery indicator on the monitor screen shows the battery level.
• In order to replace the battery, open the battery compartment, as in
point A, and remove the batteries by pulling on the tie. Insert new
battery, proceeding as in point B.
3.
Charging
• The batteries of GO 2500 4K may be charged by connecting the
device to any USB port on the computer via USB cable.
• The camera may be charged in the car, using a micro USB 5V
charger.
• The camera may be used to record while charging.
4.
Turn ON/OFF
• Press and hold the ON/OFF button for 3 to 5 seconds to turn the
camera on and off.
• The screen will switch off automatically, according to MENU set -
tings. In order to turn the screen back on, press OK.
• Press the ON/OFF button briefly to turn the camera off.