14
Q1.
A1.
Q2.
A2.
Q3.
A3.
Can I connect or disconnect TU2-ET100 while the computer is on?
Yes, you can connect or disconnect TU2-ET100 while the computer is on
because the USB interface is Plug-and-Play compliant and hot-pluggable.
After successful installation of the TU2-ET100 USB Fast Ethernet, I connected
my USB device into a USB slot, but it does not seem to work. What should I do?
Make sure that the CAT-5 cable is connected properly into your switch, or
broadband modem. Double check the connection at the other end of the CAT-5
cable, and verify that the cable is inserted properly into your TU2-ET100. Also,
verify that your switch or your broad-band modem is getting any power.
When I verify the installation of the TU2-ET100, I see an exclamation point on
my network adapter. What should I do?
Go to Control Panel and double-click the System icon. Go to the Device
Manager and expand the Network adapters heading. Double-click ASIX
ax887722 USB2.0 to Fast Ethernet Adapter (the icon that has an exclamation
point on it), and click the Driver tab. On the Driver tab, click Update Driver. Use
4. Driver Installation in this installation manual to guide you in installing your driver.
If you have any questions regarding the
TU2-ET100
, please contact Trendware
Technical Support Department.
Troubleshooting
This equipment has been tested and found to comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including interference that may
cause undesired operation.
This equipment is in compliance with the requirements of the following regulations: EN
55 022: CLASS B