5
PC or Laptop Setup Guide
Note: If you have not installed your Wireless device to your laptop
So far, please do so. For instructions on how to install your
Wireless device, please contact the manufacturer of that wireless
device.
To configure the Wireless device to work with your TPL-110AP,
please follow the following steps:
1. Plug TPL-110AP into an outlet.
2. Go to the wireless card's configuration screen or window. It
should resemble figure 1 or others.
3. Make sure Infrastructure is selected.
4. In the SSID field, type in the following: default (This is case
sensitive)
5. Make sure Fully Automatic is selected.
6. Click OK to exit the configuration window.
Note: If you are using Windows XP you will not need to configure the PCMCIA
card because Windows XP has an auto sense function included in the operating
system.
TPL-110AP Setup Guide
You will need to temporarily change the IP address of your PC/laptop
to setup your TPL-110AP. Follow these steps
depending on your operating system.
Note: If you have not changed the default Powerline password
(
HomePlug
) or you get the same subnet (10.0.0.1/16) on your network then
there is no need to continue this setup.
Windows 98 SE / ME
1. Click on Start, then Settings, and then Control Panel.
2. Double click on the Network icon.
3. Select the TCP/IP Protocol entry.
4. Click on the Properties button.
5. Select the IP Address tab.
6. Select Specify an IP address.
7. Type in the following address: 10.0.0.10.
8. For the Subnet Mask, type: 255.255.255.0.
9. Click OK to close the TCP/IP properties panel.
10. Click OK to close the Network panel.
11. Restart the PC
