TRENDnet TPE-3012LS, User Manual, Page: 88 / 187

© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid e
TPE-3012LS / TPE-3018LS
84
5. Click Apply .
6. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
7. Click OK .
Configure LLDP Port Settings
Discovery > LLDP > Port Setting
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on Discovery , click on LLDP, and click on Port Setting .
3. Select the port or ports to modify the LLDP configuration and click Edit .
4. Review the settings.
•
Mode – By default, all ports are set to transmit and receive LLDP frames
however, you can set specific configuration of LLDP frames.
o
Transmit – Only allow LLDP traffic to be transmitted from the selected
port or ports. Received LLDP traffic will be dropped.
o
Receive – Only allow LLDP traffic to be received on the selected port
or ports. LLDP traffic will not be transmitted from the port or ports.
o
Normal – Default setting. LLDP traffic can be both transmitted and
received on the port or ports.
o
Disable – Disables all LLDP traffic from being transmitted or received
on the selected port or ports.
•
Optional TLV – Select the optional TLVs (type-length-values) or additional
information to be sent in the LLDP traffic for the switch in the Available TLV list
and you can use the arrow buttons to add and remove to the
Selected TLV list.
Note: Multiple TLVs can be selected at the same time by holding the Shift or Ctrl
key.
•
802.1 VLAN Name - Select the VLAN IDs to advertise the LLDP traffic for the
switch in the Available VLAN list and you can use the arrow buttons
to add and remove to the Selected VLAN list.