TRENDnet TPE-3012LS, User Manual, Page: 51 / 187

© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid e
TPE-3012LS / TPE-3018LS
47
Port
The port section will allow you to configure the switch enable/disable state, speed,
duplex, flow control, and jumbo frame settings. Additionally, this section will also allow
you to enable/disable long PoE configuration on each port, configure error disabled
state, link aggregation settings and power savings mode.
Configure your switch ports and view port status
Port > Port Setting
This section allows you to configure the physical port parameters such as speed, duplex,
flow control, and port description. This section also reports the current link status of
each port and negotiated speed/duplex.
1. Log into your switch management pa ge (see “ Access your switch management page ”
on page 11).
2. Click on Port and click Port Setting .
3. In the left column, check the port or ports you would like to configure and click Edit at
the bottom of the page. You can configure a single port or multiple ports. State indicates
whether the port is disabled or enabled and Link Status Up or Down will indicate
whether or not the port is connected or disconnected.
4. Review the settings below, then click Apply to save the configuration changes.
•
Port – List the port number or range of ports to be configured. GE stands for
Gigabit Ethernet followed by the port number.
•
Description – Enter a comment or description text to more easily identify the
device or network connected to the specified port or ports. (Optional)
•
State – Checking this option enables the port, unchecking this option disables
the port.
•
Speed – Select the speed configuration for the port. Selecting Auto will set the
port to auto-negotiate 10Mbps/100Mbps/1000Mbps. Selecting Auto – 100M
will auto-negotiate the speed but can only link at a maximum speed of
100Mbps or below 10Mbps. If you would like to set a specific speed without
auto-negotiation, select 10M, 100M, or 1000M to lock down the port speed.
•
Duplex – Select the duplex configuration for the port. Selecting Auto will set
the port to auto-negotiate the duplex. If you would like to set a specific duplex
setting on a specific port or ports, select Full or Half.