TRENDnet TPE-3012LS, User Manual, Page: 30 / 187

© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid e
TPE-3012LS / TPE-3018LS
26
3. Before the surveillance switch can apply any configuration settings to your ONVIF
compliant IP cameras, you must authorize by entering the ONVIF administrator
credentials for each device.
Note: The IP camera administrator user name and password must be configured on
the IP cameras first before they can be used with the surveillance switch. Some IP
cameras may not have configuration options specific to ONVIF but may still comply
with ONVIF. In this case, the IP camera management access user name and password
may be the same as the ONVIF administrator user name and password.
4. To authorize an ONVIF compliant IP camera, check the IP camera in the list and click
Auth.
5. Under the IPC Authorization section, enter the ONVIF administrator user name and
password in the fields provided and click Apply . A success message will appear
indicating that the IP camera has been successfully authorized. Under the Status
column next to the device, the status will change from unAuth to Auth.
Note: If you are unable to successfully authorize the IP camera, please double check
your ONVIF administrator credentials. You can also try to reboot the IP camera.
Applying IP address settings to ONVIF authorized devices
ONVIF > IPC Discover
After ONVIF compliant devices have been discovered and successfully authorized, you
can apply IP address configuration settings to these devices from the surveillance switch
interface.
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on ONVIF and click on IPC Discover .
3. For the ONVIF devices that have been successfully authorized, check the device in the
list and click Edit .