TRENDnet TPE-3012LS, User Manual, Page: 29 / 187

© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid e
TPE-3012LS / TPE-3018LS
25
o
PD Reboot – If the ping response fails according to the time
parameters set, the switch will disable and re-enable the PoE port
attempting to automatically recover the connected PoE device.
o
Reboot&Alarm - If the ping response fails according to the time
parameters set, the switch will disable and re-enable the PoE port
attempting to automatically recover the connected PoE device and
also send out an email notification is configured.
o
Alarm - If the ping response fails according to the time parameters set,
the switch will only send out an email notification if configured.
o
Reboot Time - If the ping response fails according to the time
parameters set, enter the time in seconds from the time the PoE port
is disabled to the time the PoE port is re-enabled. (Range: 30-180)
4. After completing your configuration changes, click Apply .
5. Click Save in the top left menu to save configuration to NV-RAM.
ONVIF
This section will allow you to configure the ONVIF features available on the switch such
as ONVIF device discovery and authorization. Apply configuration settings to ONVIF
compliant IP cameras such as IP address settings, changing passwords, create users, and
firmware upgrades. The switch is capable of discovering and applying configuration
settings to ONVIF compliant devices connected to the same IP address subnet. The
Surveillance Mode User Interface may provide more graphical-based tools in monitoring
your devices and applying configuration settings.
Discovering and authorizing ONVIF compliant devices
ONVIF > IPC Discover
After the surveillance switch has discovered the ONVIF compliant device, the devices
must be authorized with the surveillance switch to apply configuration changes to the
ONVIF devices.
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on ONVIF and click on IPC Discover . The will list will display a list of the
discovered ONVIF compliant IP cameras found on your network. The list will also
display the IP address, MAC address, and port the device is connected. If the device or
devices are connected to another switch in your network, the list will display the
connected port as the uplink port from your surveillance switch to your network.