TRENDnet TPE-3012LS, User Manual, Page: 144 / 187

© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid e
TPE-3012LS / TPE-3018LS
140
4. Click Apply .
5. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
6. Click OK .
Configure Rate Limiting per port
QoS > Rate Limit > Ingress/Egress Port
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on QoS , click on Rate Limit , and click on Ingress/Egress Port .
3. In the table, select the ports to configure for QoS and click Edit .
4. Review the settings below.
Item Description
Port Select port list.
Ingress
Set checkbox to enable/disable ingress rate limit. If ingress
rate limit is enabled, rate limit value need to be assigned.
Egress
Set checkbox to enable/disable egress rate limit. If egress rate
limit is enabled, rate limit value need to be assigned.