TRENDnet TPE-3012LS, User Manual, Page: 135 / 187

© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid e
TPE-3012LS / TPE-3018LS
131
Configure IPv4 ACE
ACL > IPv4 ACE
This section allows users to configure access control entries/policies for the IPv4 ACLs
defined and filtered based on IPv4 address.
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on ACL and click on IPv4 ACE .
3. Review the settings below.
Item Description
ACL Name Display the ACL name to which an ACE is being added.
Sequence
Specify the sequence of the ACE. ACEs with higher sequence
are processed first (1 is the highest sequence). Only
available on Add dialog.
Action
Select the action for a match.
●
Permit: Forward packets that meet the ACE criteria.
●
Deny: Drop packets that meet the ACE criteria.
Shutdown: Drop packets that meet the ACE criteria, and
disable the port from where the packets were received.
Such ports can be reactivated from the Port Settings page.
Protocol
Select the type of protocol for a match.
●
Any (IP): All IP protocols are acceptable.
●
Select from list: Select one of the following protocols
from the drop-down list.
(ICMP/IPinIP/TCP/EGP/IGP/UDP/HMP/RDP/IPV6/IPV6:R
OUT/IPV6:FRAG/ RSVP/IPV6:ICMP/OSPF/PIM/L2TP)
●
Protocol ID to match: Enter the protocol ID.
Source IP
Select the type for source IP address.
●
Any: All source addresses are acceptable.
●
User Defined: Only a source address or a range of
source addresses which users define are acceptable.
Enter the source IP address value and mask to which
will be matched.
Destination
IP
Select the type for destination IP address.
●
Any: All destination addresses are acceptable.
●
User Defined: Only a destination address or a range of
destination addresses which users define are
acceptable. Enter the destination IP address value and
mask to which will be matched.