12
2. The Mouse is not detected during PC boot up.
??
Make sure the mouse works when directly plugged into the computer.
??
Make sure the mouse is a true PS/2 mouse. A combo mouse will work, as long as it is set to PS/2 mode
and the correct adapter was used.
??
Avoid moving the mouse or pressing the mouse’s buttons when switching from port to port.
??
Avoid switching ports when the PC is shutting down.
??
When you switch from one PC port to another PC port, the best scan time interval is 5 seconds
or more. Normally, it takes a couple of seconds for the VGA monitor changes from one
resolution mode to another. So, it is not recommended to set the scan interval time to below 5
seconds.
CERTIFICATIONS
FCC
This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received. Including interference that may cause undesired
operation.
CE – Certificate
This equipment is in compliance with the requirements of the following regulations: EN 55 022: CLASS B