TRENDnet TEG-S50ES, User Manual, Page: 37 / 65

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEG-S50ES
34
NOTE: The configured settings are only applied to the switch’s temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch’s NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
1. From the menu on the left: click on Save, then click the blue button Save
Settings to Flash.
2. Click Continue to return to the Web Configuration of your switch.
Configure the VLAN forwarding Table
Network > VLAN > Forwarding
This section allows you to configure your switch to standard 802.1Q VLAN mode (IVL) or
Asymmetric VLAN mode (SVL). Asymmetric VLAN allows the configuration of
overlapping untagged VLAN ports in order to create VLAN groups. It is recommended to
use the standard 802.1Q VLAN mode when possible.
Please note the following when switching between forwarding table modes:

FDB (Forwarding Database) will be cleared.

Static Unicast Address entries will be cleared.

Static Multicast Address entries will be cleared.

802.1X authenticated records will be cleared.

IGMP Snooping multicast group addresses will be cleared

When using SVL mode, Voice VLAN will not be supported.

When using SVL mode, the VID field on 802.1Q-VLAN mode will be displayed as
"N/A".
1. Log into your switch management page (see “ Access your switch management page ”
on page 7).
2. Click on Network, click on VLAN, and click on Forwarding.
3. Click the learning mode drop-down list to select the forwarding table mode and click
Apply to save settings.

IVL – Independent VLAN Learning (Default)

SVL – Shared VLAN Learning (also known as asymmetric VLAN)
NOTE: The configured settings are only applied to the switch’s temporary memory and
will be lost upon the next power-cycle. Please follow these next steps to save the
configurations to the switch’s NV-RAM to ensure the settings will remain throughout
power-cycles and reboots:
1. From the menu on the left: click on Save, then click the blue button Save
Settings to Flash.