TRENDnet PoE Web Smart Switch Series, User Manual, Page: 69 / 138

© Copyright 2018 TRENDnet. All Rights Reserved.
51
TRENDnet User’s Guide
PoE Web Smart Switch Series
Static Multicast
Add static multicast entries to the switch
Network > Static Multicast
In this section, you can add static multicast entries to the switch configuration.
1. Log into your switch management page (see “ Access your switch management page ”
on page 5).
2. Click on Network and click on Static Multicast.
3. Review the settings.

802.1Q VLAN – Enter the VLAN ID where the multicast group MAC address will
reside.
Note: By default, all switch ports are part of the default VLAN, VLAN ID 1.

MAC Address – Enter the multicast group MAC address.

Group Member – Check the port(s) where the MAC address will reside.
Note: You can click All to select all ports.
Click Apply to add the Static Multicast Group entry to the list.
In the list, you can click Modify to modify an entry or click Delete or delete the entry. If
the entries span multiple pages, you can navigate page number in the Page field and
click Go or you can click First, Previous, Next, and Last Page to navigate the pages.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.