BS/JIG
-1-
The following symbols are used throughout this
manual:
Denotes risk of personal injury, loss of
life or damage to the tool in case of non-
observance of the instructions in this
manual.
Refer to the instruction manual of
your power tool.
This unit must not be put into service until it has
been established that the power tool to be
connected to this unit is in compliance with
2006/42/EC (identified by the CE marking on the
power tool).
TECHNICAL DATA
Jig thickness
12mm
Cutter size for routing recess
12.7mm
Cutter size for drip groove
R2.5mm radius
Guide bush size
30mm
Guide bush size (drip groove) 16mm
Standard corner radius
25mm
Reduced corner radius
7mm
Sink depth min.
440mm
Sink depth max.
515mm
Sink width max.
1050mm
Recess depth min.
445mm
Recess depth max.
520mm
Recess width max.
630mm or
1030mm*
Weight 3.68kg
* if overlapping the longer slots.
If you require further safety advice,
technical information or spare parts,
please call Trend Technical Support
or visit www.trend-uk.com
Dear Customer
Thank you for purchasing this Trend product, we
hope you enjoy many years of creative and
productive use.
This jig should give lasting performance if used
in accordance with these instructions.
CONTENTS
TECHNICAL DATA _____________________1
SAFETY ____________________________2-3
ITEMS ENCLOSED
__________________
4
DESCRIPTION OF PARTS_______________4
ACCESSORIES
– Recommended Cutters
________________5
– Sub-base Set
________________________5
– Guide Bushes
________________________6
– Clamps
_____________________________6
– Carry Case
__________________________6
ASSEMBLY
– Measuring & Calculating Recess Size
_____7
– Marking out the Recess
_______________8
– Example
___________________________9
OPERATION
– Positioning the Jig on the Worktop ______
10
– Routing the Worktop__________________
11
– Routing the Water Drip Groove / Channel _
11
– Reduced Radius Corner ______________
12
MAINTENANCE ______________________12
ENVIRONMENTAL PROTECTION________12
GUARANTEE ________________________12
TROUBLESHOOTING _________________12
SPARE PARTS
– Spare Parts Diagram & List
____________IB
INTENDED USE
This jig is intended for use with a plunge router
fitted with suitable guide bush and router cutter
to rout the recesses into worktops for single or
double Belfast Sinks and Butler Sinks.
The jig also enables you to accurately rout the
drip channel groove on the underside of
worktops.
MANU/BS v1 25/3/11 16:33 Page 1
