MRW Operation Manual
14
Rev. 2, 1.12.2016
Assembly & Installation
The weighing scale is delivered in a partly dismantled condition. Assemble the individual
components in the following sequence:
Place your machine on a level, clean, and dry surface to obtain accurate
readings.
Place the plastic platter on top of the scale, flat side facing up so the platter
sits firmly on the machine with the four “legs” inserted into the corresponding
four receptacles.
Place the stainless steel platter on top of the plastic platter with the flat side
facing up.
Unwrap and place the clear plastic bowl, open side facing up, on top of the
stainless platter.
Connecting the AC Adapter
The following Safety recommendations must be observed when connecting the balance:
The Scale should only be connected to the mains voltage socket with the power adapter
supplied.
Check before connecting the power adapter to the mains socket, that the
operating voltage stated on the power adapter complies with the local mains voltage.
If the operating voltage is not the same as the mains voltage, the power adapter must
not be connected to the mains socket and contact customer service.
Placement of Scale
The location in which the scale is placed is very important in order for the scale to work
to its full potential. Certain conditions can affect the capabilities of the scale, conditions
like: the presence of air flow, variations in temperature, and direct sunlight. Please
follow the recommendations given below in choosing a location to place your scale.
Place the scale on a solid, firm and preferably vibration-proof, horizontal base
Make sure that the weighing machine cannot be shaken or knocked over
Protect from direct solar radiation
Avoid drafts and excessive temperature fluctuations
Avoid placing the scale near or on any magnetic surfaces
