Trebs Comfortair 99324, Manual

Page: 26 / 45

26
3 Commissioning
This chapter provides you with important safety notices during the initial commissioning of the
device. Observe the following notices to avoid dangers and damages.
3.1 Safety information
WARNING
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:

Packaging materials may not be used for playing. There is a danger of suffocation.
3.2 Delivery scope and transport inspection
As a rule, the humidifier is delivered with the following components:

Humidifier

Operating Instructions

Remote control
PLEASE NOTE

Examine the shipment for its completeness and for any visible damages.

Immediately notify the supplier about any incomplete shipment or damages as a result of
inadequate packaging or due to transportation.
3.3 Unpacking
Unpack your device as follows:

Take out the device from the box and remove the interior and exterior packaging.

Clean the appliance thoroughly before the first use. (see chapter Cleaning and maintenance)
3.4 Disposal of the packaging
The packaging protects the device against damages during transportation. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of view and
can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the quantities of
accumulated waste. Take any packaging materials that are no longer required to “Green Dot”
recycling collection points for disposal.
PLEASE NOTE

If possible, keep the original packaging for the device for the duration of the guarantee period
of the device, in order that the device can be re-packaged properly in the event of a guarantee claim.
3.5 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must fulfill
the following prerequisites:

The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity.

Choose the setup location in such a way that children cannot reach the device.

The device is not intended to be installed in a wall or a built-in cupboard.

Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.

The electrical socket must be easily accessible so that the power lead can be disconnected
easily, in the case of an emergency.

The installation and assembly of this device in non-stationary setup locations (e.g. on ships)
must be carried out by specialist companies / electricians, provided they guarantee the prerequisites
for the safe use of this device.