Finally, wipe the motor base clean with a damp cloth to remove any residue, and dry thoroughly. Never submerge the
motor base in water or other liquids, or place in a dishwasher.
Any other servicing should be performed by an authorized service representative.
Troubleshooting
TECHNICAL DATA
Service
If you have any further questions about the product after reading this manual, please contact the Trebs customer service:
.
Trebs BV
Thermiekstraat 1a, 6361 HB, Nuth, The Netherlands, Email:
, Internet:
www.trebs.nl
CE
Problem:
Solution:
My blender is not turning on or going
into Standby mode?
Be sure the blade assembly is on the jar or cup correctly. Be sure it is pushed all
the way onto the base.
1. Plug blender into an independent outlet.
2. Make sure blender is securely plugged in.
3. Check the outlet for power; try plugging into a different outlet.
4. Check your home's circuit breaker.
The blender stopped running.
The motor could have overheated. The resettable fuse, which protects the
motor due to overloading, may have been tripped. When this happens, to
reset the appliance unplug the unit and let it cool for a minimum of 15 minutes.
Then, reduce the contents of the blender jar and/or clear any jams. Restart the
unit as noted in the operating directions.
The rubber gasket won’t come out from
the blade assembly for cleaning.
Run under water and tap on the edge of sink upside down to loosen the gasket.
The blade assembly is hard to remove
after blending.
The ingredients cause pressure, and with the air tight seal, pressure builds up
creating a vacuum or a suction effect. This is normal.
Unit appears to be leaking
1. Check rubber gasket. Make sure it's flush with blender assembly.
2. Make sure rubber gasket is properly in place.
3. Make sure rubber gasket is not damaged.
Rated voltage:
220-240V~50Hz
Rated current:
1.5A
Rated power input:
350W
Filling capacity:
35oz (1000mL)
Dimensions:
162mm (L) x140mm (W) x 377mm (H)
Weight (without package):
1.4kg
Summary of Contents for 99242
Page 33: ...cress and lime slices ...
