Trebs 49200, Manual

Page: 7 / 50

7
Light (Child Lock)
Shortly press the light button to change the light function from, high to low or off.
Long press (3sec) the Light button to activate the child lock. Once activated a lock will appear on the control panel.
The 49200 settings can not be changed in Child lock setting.
UV (HEPA filter indicator light)
Press the UV button to activate or deactivate the UV light
CHANGING THE HEPA FILTER
The HEPA filter (SKU: 49201) requires to be replaced approximately every 2200 hours of operations.
When the HEPA filter (SKU: 49201) requires to be replaced the UV/HEPA filter indicator light will keep flashing red.
The HEPA filter for the Trebs 49200 can be bought separately through your Trebs dealer or the Trebs service line.
Trebs 49200 HEPA filter SKU: 49201
Follow the below steps to successfully change the HEPA filter.
Always make sure the 49200 is unplugged before opening the device or changing the filter.
Open the back cover Remove the old filter from
the Trebs 49200
Dispose of the old filter
according to local regulations
Carefully unpack the new Trebs
HEPA H13 filter
SKU: 49201
Insert the new HEPA filter into
the 49200.
Open side facing up
Close the back cover
Packaging
Open
Close
After changing the filter, long press the UV/HEPA filter indicator button for 7 seconds to reset the HEPA filter timer.
After the reset the red light will stop blinking.
Note: The device will operate normally, even if the HEPA filter indicator is signalling the HEPA filter to be replaced.