TREASUREHUNTER3D
Makes underground treasures visible
Instruction manual 12
Turn it on
1.
Move the slider switch on the Sensor unit to ON position in order to turn it on�
Green LED
will indicate the sensor is turned ON�
Orange LED
will indicate that the sensor is ready to be used�
2.
Move the slider switch on the Receiver module to turn it on�
Green LED
will indicate the sensor is turned ON�
Orange LED
should turn ON, indicating that a link between the Sensor and Receiver unit is established�
3.
Turn ON drone & drone Remote controller�
(refer to drone user manual and instructions)
TROUBLESHOOTS
• If
green LEDs
are not turn on please check batteries are full and properly installed�
• If
orange LED
on Receiver unit will not start to blink check if antennas on both units are properly installed�
Smartphone application
DroneRover uses iOS application to navigate drone, display drone, detector information and scan results�
To start using application:
1.
Install DroneRover application�
Applications can be downloaded from
http://www�treasurehunter3d�com/downloads
or installed from AppStore�
2.
Make sure iPhone bluetooth is turned on�
3.
Make sure sensor and receiver unit are both turned ON�
4.
Run the application�
5.
The Bluetooth LED indicator on the receiver unit will turn blue indicating the
smartphone is connected with a DroneRover sensor�
Congratulations, the DroneRover sensor is now ready to be used!
