4
3
S T E P 4
Operating Umbrella
Crank handle clockwise to open umbrella to its fully open position (Fig. 11).
To tilt, simply twist the collar in clockwise direction (Fig. 12).
S T E P 3
Rechargeable Battery Pack
Turn umbrella in upright position. Insert bottom pole into free standing base (Fig. 6) or
through table top.
IMPORTANT:
If using table application, please take note of measurements
below to ensure table can accommodate battery pack (Fig. 7).
Free Standing
Table Application
18.3”
4.6”
1.4”
9.1”
32”
2”
DIA.
28”
3.5”
(Height to TABLE
BOTTOM)
(BOTTOM POLE)
TABLE
UMBRELLA
HOLE
BATTERY
+
POLE & BATTERY
CLEARANCE
3.5”
DIA.
(WHEN ATTACHED)
(Fig. 6)
(Fig. 7)
(Fig. 8)
BATTERY
3.5”
DIA.
3.5”
DIA.
(Fig. 11)
(Fig. 12)
Attach rechargeable battery pack onto bottom pole (Fig. 8).
Charging Battery Pack:
You must fully charge battery pack prior to first use.
To charge battery, remove plug cap from charging port on
battery pack. Using the supplied power cord/transformer,
insert power supply into charging port. Plug other end of
power supply into wall outlet for 6 hours to fully charge
(Fig 9). When fully charged, all lights displayed on battery
pack will be lit.
Battery Status:
Lights on the battery pack will indicate
battery charge level (Fig. 10). Four lights indicates full charge,
while one is low battery. When battery is low, you may
charge battery pack while attached to frame, or removed
from frame, using supplied power cord/transformer.
(Fig. 9)
Note:
The transformer output power is 12V. It is normal for transformer to get warm after
long period of use. Avoid sun and water on power supply/transformer to increase lifetime
use. Be sure not to drop transformer or battery pack. Only use Power Cord/Transformer
supplied.
(Fig. 10)
