Pag. 4
Pag. 4
INSTALLING A DVR-6 WITH A WIRELESS “Pegaso” CONTROL PANEL:
1- Programming a control panel to function with the DVR-6:
Press the button on the back side of the DVR -6
for 2 seconds and release. A beep will be heard. With-in 15 seconds of this beep you must have the control
panel transmit its “Pegaso” protocol code to the DVR-6. A simple way of getting this done is by arming the
control panel with the keychain transmitter PEG-3. Wait a few second and you will hear the DVR-6 emits a
series of 5 beeps. This indicates that the DVR-6 has learned the control panel code. If you hear only 2
beeps, this indicates that the code has not been learned by the DVR-6 and you must repeat the learning
operation once again until the 5 Beeps are heard. Once this has been successfully done, proceed with 2
below.
2-
The DVR-6, acts also as a normal PIR sensor and now you must have the control panel with which it must
function learn the DVR-6 “Pegaso” PIR sensor code transmission. Proceed as follows: Read carefully the
“Pegaso” code learning of the panel and set the panel into learn mode. Then press on the back side of the
DVR-6 the transmitting code button for 2 seconds and release. After the release you will hear a beep and the
code transmission to the control panel will take place. The control panel will emit a signal based on how it is
described in the panel instruction manual. This will indicate that the code has been learned.
-
To cancel the “Pegaso” codes learned by the DVR-6:
Press the learn button for 15 seconds and release.
The DVR-6 will emit a long beep as indication that the code has been canceled.
PRECAUTIONS:
-
The DVR-6 is made for indoor use only. It is not water proof.
-
The manufacturer is not responsible for inappropriate use of this product.
-
Do not install the DVR-6 so that the on–board Camera and PIR sensor faces direct sun light
-
Do not install above heater other devices that cause air to move rapidly.
- Do not install behind curtains or blinds.
- Do not install behind objects that will interfere with the line of sight of the DVR-6
-
It is necessary to periodically clean the DVR-6 without causing water penetration.
-
The camera lens must remain dust free. Clean with dry dust towel.
-
The DVR-6 is a very sophisticated high precision electronic product and must be treated as such.
Latest revision: 11-08-2013
Do not litter. Dispose of the device and the batteries
in the designated disposal containers at the end of its
lifetime.
Do not litter. Separate and discard the packaging
materials in the containers (depending on the laws in
force).
®
TRE i SYSTEMS S.r.l
Via del Melograno N. 13 - 00040 Ariccia, Rome Italy
Tel: +39 06 97249118 Fax: +39 06 45557618 : Tre i Systems
e-mail: [email protected] Website: www.treisystems.com
TRE i SYSTEMS
®
is not responsible for inappropriate use or installation of the products manufactured and declines
any responsibility for not observing the local laws in force.
TRE i SYSTEMS
®
reserves the right to make changes or improvements on the present product and this instruction
manual without previous notice.
For any problems contact
TRE i SYSTEMS
®
local sales office or service centre.
