2
Valve
Custom
TRAYNOR YCV80
CAUTION: REPLACE WITH
SAME TYPE FUSE AND RATING
ATTENTION: UTILISER UN FUSIBLE DE
RECHANGE DE MEME TYPE ET CALIBRE
Send
Balanced
Line Out
Phones /
Line Out
Footswitch
Return
Ch. Select
/ Boost
FUSE
On
Extension
Speaker
Send
Trim
Return
Trim
Speaker
Defeat
Loop Thru
Effects
Tip: Send
Ring: Return
Parallel Effects Loop
Power
DESIGNED & MANUFACTURED BY
YORKVILLE SOUND • T
oronto, CANADA
MODEL TYPE: YS1034
A-Z438R / 3v0
SPEAKER EMULATOR
(PRE-MASTER)
D
Y
NA
- SOU
N
D
DISCONNECT POWER WHEN
REPLACING TUBES
DÉBRANCHÉ L’APPAREIL AVANT
DE REMPLACER LES LAMPES
5881
V7
POWER
5881
V6
5881
V4
5881
V5
PREAMP
12AX7
V2
12AX7
V1
SPLITTER
12AX7
V3
THIS UNIT MUST BE GROUNDED!
CET APPAREIL DOIT ETRE MIS Á TERRE!
DISCONNECT POWER
BEFORE SERVICING!
DEBRANCHER L’APPEREIL AVANT
D’ENLEVER LES COUVERCLES!
Gain
0
5
10
0
5
10
0
5
10
0
5
10
0
5
10
0
5
10
0
5
10
0
5
10
0
5
10
0
5
10
0
5
10
CHANNEL
SELECT
1
2
Volume
Middle
Bass
Treble
Volume
Middle
Bass
Treble
Reverb
Master
Volume
Power
STANDBY
BRIGHTNESS
SCOOP
EXPANDER
BOOST
Input
Chassis Layout
Top
1
Input jack – ¼-inch phone jack.
2
Channel 1 Gain & Volume Controls.
3
Channel 1 Boost Switch – Activates the boost circuitry.
4
Boost LED – Illuminated Red when the boost is active.
5
Channel 1 Indicator LED – Illuminates Yellow when active.
6
Channel 1 Tone Controls – Treble, Bass, & Middle.
7
Channel Select Switch – Channel 1 is optimized for lead, Channel 2 for clean
8
Channel 2 Volume Control.
9
Channel 2 Indicator LED – Illuminates Green when active.
10
Channel 2 Brightness Switch – Add sparkle to your clean sound.
11
Channel 2 Tone Controls – Treble, Bass, & Middle.
12
Master Volume- Controls overall volume of both channels.
13
Reverb Control – Adjusts the Accutronics® reverb level for both channels.
14
Standby Switch – Activates standby mode to keep the tubes warm while the amp is not in use.
15
Power Indicator Jewel – Illuminates red when in Active mode, and yellow when in Standby mode.
16
Scoop Switch – Adds mid scoop and big bottom end to Channel 1.
17
Expander Switch – Adds deep bottom and sparkling highs to Channel 2 sound.
Rear
18
Fuse and Power Cord
19
Power Switch.
20
Send / Rtn (Efx/Line) jacks – ¼-inch phone Input and Output jacks with individual level controls for send and return
21
Channel Select Footswitch jack – uses a ¼-inch TRS standard latching dual-footswitch.
22
Extension Speaker jack –1/4 inch phone jack.
23
Loop Thru – ¼-inch TRS jack for connecting effects pedals.
24
Direct Out – Balanced XLR output with speaker emulator compensation for recording or direct
connection to mixing consoles.
25
Headphone Output – ¼-inch phone jack with speaker emulator compensation.
26
Speaker Defeat – Disengages the signal from the power amplifier to the speakers.
2
7
3
8
9
1
4
5
6
17
11
12
13
14
15
19
18
23
24
2
10
16
18
22 26 21
25