SLAYER PRO 4X4 • 11
• Always have the transmitter and receiver turned on before you
start the engine. Never turn the radio system off while the engine
is running. The on/off switch in the model only turns the receiver
on and off. It does not turn off the engine.
• Always use new or freshly charged batteries for the radio system.
Weak batteries will limit the radio signal between the receiver
and the transmitter. Loss of the radio signal can cause you to lose
control of your model.
RADIO SYSTEM BASIC ADJUSTMENTS
Steering Trim
The steering trim knob located on the face of the
transmitter adjusts the neutral (center) point of the
steering channel. If your model pulls to the right or left
when the steering wheel is centered, turn the knob until the model
drives straight when the steering wheel is centered.
Servo Reversing
The TQ transmitter has been programmed with the correct servo
direction settings for your model and should not require adjustment.
These instructions are for reference and troubleshooting only.
Reversing a channel reverses the direction of the corresponding servo.
For example, if you turn the steering wheel to the right and the model
turns left, you would reverse Channel 1 to correct the servo direction.
Use the following procedures to reverse the steering or throttle
channel if necessary.
Note:
Servo reversing should only be required if you
accidentally reset the direction of a channel, or in the unlikely event that
your transmitter was not programmed properly at the factory.
Do not
reverse the throttle or steering channels unless necessary.
Steering reversing procedure:
1. Press and hold the SET button on the transmitter for two
seconds. The status LED will flash green.
2. Turn and hold the steering wheel to the full left or full right
position (it does not matter which position you choose).
3. While holding the steering wheel in position, press the SET
button to reverse the channel.
4. The channel is now reversed. Confirm correct servo operation
before running your model.
Throttle reversing procedure:
1. Press and hold the SET button on the transmitter for two
seconds. The status LED will flash green.
2. Move and hold the throttle trigger to the full forward or full
brake position.
3. While holding the throttle trigger in position, press the SET
button to reverse the channel.
4. The channel is now reversed. Confirm correct servo operation
before running your model.
Warning:
Changing the direction of the throttle servo will also
change its neutral position. Be certain to confirm the throttle servo
properly closes the engine’s throttle opening when the transmitter’s
trigger is at neutral.
RADIO SYSTEM CONTROLS
Make certain the model’s
receiver antenna is properly
installed before operating
your model. See “Installing
the Receiver Antenna.”
Failure to properly install the
receiver antenna will result in
greatly reduced radio range
and potential loss of control.
Remember to always turn the
TQ transmitter on first and off
last to avoid loss of control
and damage to your model.
TRAXXAS TQ
2.4GHz RADIO SYSTEM
Forward
Neutral
Brake
TURN
R
IG
H
T
T
U
R
N
LE
FT
