3. Feed the LED boards of the roof visor harness (Q)
through the hole in the front right corner (passenger
side) of the roof.
4. Install the LED boards in the visor lens; reinstall
the lens in the roof visor.
Note orientation of the
lens!
Secure the lens with the 3x4mm set screws (4)
removed during disassembly.
5. Route the harness connecting the two circuit boards
through the wire retainers on the roof visor (Fig. 7).
6. Reinstall the roof visor and visor retainer using the
2.6x6mm button-head cap screws removed during
disassembly.
7. Secure the wiring to the visor retainer with the
included zip ties (3) (Fig. 8).
8. Plug the included jumper (green color band) into
the port located on the small circuit board attached
to the roof visor light harness (Fig. 9).
Note:
The jumper will allow the LED
lights to go into full power (high beam) mode. The jumper is not required
for the LED lights to function (the lights will remain in low power (low
beam) mode if the jumper is not used).
Wire Routing (Fig. 12)
When installing the LED light harnesses, note where the installation begins
and ends in the Wiring Diagram (Fig. 12). Use zip ties to secure the wiring to
the body in the locations provided. The zip ties do not need to be tight; allow some slack for wire movement.
Distribution Block Installation (Fig. 10)
1. Install the distribution block mount (R) and secure with the included 2.6x8 mm button-head screws (2) as shown in Fig. 10.
2. Plug the connectors from the LED light wire harnesses into the ports of the distribution block (S). Match the color band on the wire harnesses with the corresponding color
of each port indicator on the distribution block (white for headlights, red for tail lights, yellow and green for roof visor lights).
3. Use the included 2.6x8mm button-head screws (2) to secure the distribution block to the mount.
Fig. 10
2.6x8 BCS
Wiring Diagram
Fig. 12
GREEN & YELLOW
(Roof Visor Light Wiring)
Headlight, Turn Signal, and Front Side Marker Light Wiring
Tail Light Wiring
Roof Visor Light Wiring
FRONT
DISTRIBUTION BLOCK
DISTRIBUTION BLOCK PORTS
BLUE*
RED (Tail Light
Wiring)
WHITE (Headlight, Turn Signal,
& Front Side Marker
Light Wiring)
*For use with optional accessories.
Not used with this LED light kit.
To LED Lighting Module
From Roof Visor Lights
BOTTOM VIEW
Fig. 8
Fig. 7
Fig. 9
Jumper
2.6x8 BCS
