6
Install the accessory power supply on the chassis.
3x10mm BCS
Warranty Information
Traxxas electronic components are warranted to be free from
defects in materials and workmanship for a period of 30 days from
the date of purchase.
Limitations:
Any and all warranty coverage does not cover
replacement of parts and components damaged by abuse, neglect,
improper or unreasonable use, crash damage, water or excessive
moisture, chemical damage, improper or infrequent maintenance,
accident, unauthorized alteration or modification or items that are
considered consumable. Traxxas will not pay for the cost of shipping
or transportation of a defective component to us.
Traxxas Lifetime Electronics Warranty
After the expiration date of the warranty period, Traxxas will repair
electronic components for a flat rate. Please visit Traxxas.com/
support for a current schedule of warranty costs and fees. The
covered repairs are limited to non-mechanical components that
have NOT been subjected to abuse, misuse, or neglect. Products
damaged by intentional abuse, misuse, or neglect may be subject
to additional charges. Traxxas liability, in no case, shall be greater
than the actual purchase price of this product. For replacement,
product must be returned in brand new condition, with packaging
and itemized sales receipt.
If you have questions or need technical assistance, call Traxxas at
1-888-TRAXXAS
(1-888-872-9927) (U.S. residents only)
This device complies with FCC Part 15 & IC RSS-210
rules subject to the following conditions: 1) This
device may not cause harmful interference, and 2) This
device must accept all interference received, including
interference that may cause undesired operation.
Important Note!
Use the included power tap as the direct battery source for
the accessory power supply. Do not connect to the accessory BEC power output
on the ESC (if equipped). Connecting high-load accessories to the power supply
while it is plugged directly into the ESC could overload the speed control’s BEC
circuit. This may cause the speed control to go into thermal protection mode or
could cause damage to the speed control.
Route the wire harness from the front bumper to
the accessory power supply. Use the included
zip ties (3) to secure the harness.
Note: Ensure
the wire harness is kept away from any
moving parts and heated surfaces.
Plug the black male connectors
from the accessory power supply
into the black female connectors
from the front bumper and roof
skid plate wire harnesses.
Plug the red power tap male connector into the
red female connector from the accessory power
supply.
The accessory power supply and LED
lights will turn on when a battery is connected.
Always disconnect the battery when not in use.
8
2.6x8mm BCS
(self-tapping)
Install the cover on the power tap.
ESC Power
Tap Cover
ESC Wiring
Wiring Diagram
9
Roof Skid Plate
High-Current Connector
with installed Power Tap
Electronic Speed
Control
Accessory Power
Supply
Front Bumper
Do not use for
this accessory
7
High-Current
Connector
Attach the power tap to the High-Current Connector of the electronic speed
control (ESC).
ESC
Power Tap
ESC Wiring
During installation, be sure that
the terminals of the High-Current
Connector and the power tap
make full contact.
ESC Wiring
Power Tap
CAUTION: RISK OF DAMAGE TO
ACCESSORIES!
Note the polarity and wire color on the
pre-installed wires on the power tap. Ensure the polarity is correct during
installation on the High-Current Connector: red (+) (positive), black (-) (negative).
Wire colors
mismatched
