NITRO SLASH • 9
Your model is equipped with the Traxxas TQi 2.4GHz transmitter. The transmitter has two channels: channel one operates the steering,
and channel two operates the throttle. The receiver inside the model has three output channels. Your model is equipped with two servos
and a receiver.
NITRO SLASH WIRING DIAGRAM
TRAXXAS TQ
i
RADIO SYSTEM
TRANSMITTER AND RECEIVER
TRAXXAS TQ
i
RADIO SYSTEM
Applying The Decals
The main decals for your model
have been applied at the
factory. Additional decals are
printed on self-adhesive clear
mylar and are die-cut for easy
removal. Use a hobby knife
to lift the corner of a decal
and lift it from the backing.
To apply the decals, place one
end down, hold the other end
up, and gradually smooth the
decal down with your finger
as you go. This will prevent air
bubbles. Placing both ends of
the decal down and then trying
to smooth it out will result in
air pockets.
3
V/T
- Voltage/Temp Sensor Port*
RPM
- RPM Sensor Port*
BATT/CH5
-
Battery
CH4
-
Channel 4*
CH3
-
Channel 3*
CH2
-
Throttle Servo
CH1
-
Steering Servo
CH1
-
Channel 1*
*Not used
Antenna
On/Off
Switch
Receiver
4-Cell
Battery Holder
Channel 1
Steering Servo
Channel 2
Throttle Servo
Steering
Trim
Multi-Function
Knob
Throttle
Trigger
Throttle Neutral
Adjust
Steering Wheel
Power Switch
Battery Compartment
Set Button
Menu Button
Red/Green Status LED
see page 35 for more info
Link
Button
LED
Sensor Expansion
Port
**
** Accessory sensor expansion port for use with the Telemetry Expander Module (see Traxxas.com and included materials for more information).
