Traxx Constructions Products Operations Manual – DBM 31PH 3
1.
INTRODUCTION
1.1
Important Information
This manual is written for users of the
DBM
31PH
and contains information on setting up, operating and maintaining the
DBM
31PH
.
This manual is only applicable to the
DBM
31PH
Core Drilling Machine. You will find the machine type designation on the type plate
mounted on the machine.
2.
GENERAL INFORMATION
Read through the operator’s manual carefully and understand the contents before using the core drill rigs.
1. Warning! Do not wear loose clothing such as ties, rings, bracelets or any other jewellery, as they could be caught by the machine
during operation.
2. Always wear safe shoes with a non-slippery sole, safety glasses or a visor. A hairnet is recommended for long hair. Use face and
dust mask when the drilling procedure is dusty.
3. Do use the machine and its accessories exclusively for the work it’s intended for.
4. For your work’s safety and efficiency, please check if any part may be damaged before starting the machine.
5. Check all fasteners to ensure that no fastener is loose before switching ON.
6. For stable and safe performance, please use the appointed or authorized core bits.
7. Do not run the machine under unmanned operation.
8. Do not, under any circumstance, touch the running core bits.
9. Take care that all non-operators keep a safe distance from the machine, especially children.
10. To avoid accidents, the throttle should be in idle state when engine is running, that is, the clutch is in a state of separation to ensure
that the core bits is not running.
11. Do not use machine indoors.
12. When the machine is in use, it should be more than 3 feet away from flammable substances and materials.
13. Do not smoke or allow naked flames in the area around the running machine while it is running.
14. Check the engine oil level before starting the machine. Do not start the engine in the absence of oil.
15. Always switch OFF the engine before checking the oil level or re-oiling. In the horizontal position, the oil level from oil filler hole
should be 5mm at least, do not overflow when re-oiling.
16. The oil grade: SAE 10W – 30.
17. Check whether there is sufficient fuel before starting the machine. Enough fuel helps to start the engine normally.
18. Always switch OFF the engine before checking the fuel level or refueling. In the horizontal position, the fuel level from fuel filler hole
should be 10mm at least, do not overflow when refueling.
19. The fuel grade: unleaded petrol, octane number 86 or above grade.
20. Before switching ON, check whether air filter is clean, and no damage, no dirt.
21. Check core bits before switching ON to ensure that the core bits connect correctly, and there is no debris inside.
